• Hot Dip Galvanized Trailers and Skids, Radiator Enclosure, Battery Box and Wheels.

• Zinc Plated Jacks.

• Emissions Certified Engines by CAT, Perkins. and John Deere.

• DOT LED lights.

• Electric Brakes with Safety breakaway.

• Locking Battery Box.

• Guards are fitted as standard to all moving parts.

The Priming System:

The POWER PRIME line of end suction centrifugal pumps come with a fully automatic priming system built into the design. This enables the pump to self-prime from completely dry conditions, even with extended suction lines.

The priming system utilizes a standard air compressor, which feeds a pneumatic ejector mounted above the air/water separation tank. With this device, suction lifts up to 28ft. (8.5m) can be achieved.

Solids Handling:

The pumps can handle raw unscreened sewage, trade effluents, thick slurries and solids from 1.5” (38mm) to 3.5" (90mm) in diameter.

The Impeller:

Impeller designs include a three vane design for pumping under most conditions. The impeller is mounted on a 431 stainless steel shaft fitted to a cast iron bearing bracket; which also provides concentric location for the pump volute. The impeller is of a fully open design with balance holes and back pump out vanes.

The pump casing is fitted with replaceable wearing parts, consisting of the impeller and wear plates, to simplify and reduce costs of pump rebuilds.

Mechanical Seals:

The mechanical seal is leak tight and suitable for sewage and sludge. The seal uses a silicon carbide rotating face mounted to a silicon carbide stationary seat with Buna -N  or Viton seal elastomers. The arrangement incorporates an oil-filled seal housing to lubricate the seal faces.

Material Options:

Material options include: Ductile Iron bearing frame with an Iron pump casing and fitted with 316 stainless steel or 2% chromium steel alloy (340 BHN) impeller and wearplates; complete 316 stainless steel wet ends; complete CD4MCu wet ends; or complete high chromium alloy (500 BHN) wet ends.